#linuxcnc-devel | Logs for 2019-04-12
Back
[02:58:07] -!- c-log has quit [Ping timeout: 240 seconds]
[03:01:45] -!- c-log has joined #linuxcnc-devel
[03:18:38] -!- c-log has quit [Ping timeout: 246 seconds]
[03:22:13] -!- c-log has joined #linuxcnc-devel
[05:12:02] -!- alex_joni has quit [Ping timeout: 250 seconds]
[05:13:45] -!- alex_joni has joined #linuxcnc-devel
[05:13:45] -!- mode/#linuxcnc-devel [+v alex_joni] by ChanServ
[07:52:51] -!- c-log has quit [Ping timeout: 250 seconds]
[07:55:06] -!- c-log has joined #linuxcnc-devel
[08:45:40] -!- mal``` has quit [Quit: Leaving]
[08:46:28] -!- mal`` has joined #linuxcnc-devel
[10:55:23] -!- Roguish_VM has quit [Read error: Connection reset by peer]
[12:22:14] -!- pcw_home has joined #linuxcnc-devel
[13:32:48] -!- mal`` has quit [Quit: Leaving]
[13:37:48] -!- mal`` has joined #linuxcnc-devel
[16:18:01] -!- jthornton has quit [Read error: Connection reset by peer]
[16:18:02] -!- JT-Shop2 has quit [Read error: Connection reset by peer]
[16:18:02] -!- JT-Shop has quit [Read error: Connection reset by peer]
[16:18:27] -!- jthornton has joined #linuxcnc-devel
[16:18:36] -!- JT-Shop2 has joined #linuxcnc-devel
[16:18:42] -!- JT-Shop has joined #linuxcnc-devel
[17:33:07] <KimK> Could someone please remind me of the link to the test/proposed new LinuxCNC install disk (stretch?) I thought it was on jepler's unpythonic.net, but I have been searching there without success. Advice and comments appreciated. Thanks in advance.
[17:39:10] <Tom_L> http://www.linuxcnc.org
[17:39:11] <Tom_L> that?
[17:50:05] <KimK> Tom_L: I think so, yes, thanks! I'll take a look.
[20:50:16] <Tom_L> KimK if you care to build your own: http://gnipsel.com
[20:51:00] <jthornton> be better if you built a new livecd https://github.com
[22:09:27] -!- Roguish has quit [Quit: ChatZilla 0.9.92-rdmsoft [XULRunner 35.0.1/20150122214805]]
[22:13:41] -!- c-log has quit [Ping timeout: 246 seconds]
[22:15:04] -!- c-log has joined #linuxcnc-devel
[23:39:53] -!- ve7it has joined #linuxcnc-devel