#linuxcnc-devel | Logs for 2019-04-14
Back
[00:32:42] -!- jthornton has quit [Read error: Connection reset by peer]
[00:35:27] -!- JT-Shop2 has quit [Ping timeout: 240 seconds]
[00:35:38] -!- JT-Shop has quit [Ping timeout: 250 seconds]
[00:43:03] -!- JT-Shop has joined #linuxcnc-devel
[00:43:19] -!- jthornton has joined #linuxcnc-devel
[00:44:50] -!- JT-Shop2 has joined #linuxcnc-devel
[00:52:43] -!- MarkusBec has quit [Ping timeout: 264 seconds]
[00:55:31] -!- MarkusBec has joined #linuxcnc-devel
[01:02:18] -!- c-log has quit [Ping timeout: 246 seconds]
[01:08:40] -!- c-log has joined #linuxcnc-devel
[01:15:21] -!- c-log has quit [Ping timeout: 252 seconds]
[01:17:01] -!- c-log has joined #linuxcnc-devel
[01:23:37] -!- ve7it has quit [Remote host closed the connection]
[01:51:27] -!- c-log has quit [Ping timeout: 240 seconds]
[01:54:35] -!- c-log has joined #linuxcnc-devel
[03:37:04] <KimK> jthornton: If I was going to follow your instructions for Mint 19.1-rt today, would you suggest I use 4.19.31 (the latest one that I can see a corresponding 4.19.31-rt18 patch for) instead of 4.19.1 ? They go up to 4.19.34 if we just want the newest one, but no patches (yet?) for .32, .33, .34 . Thanks in advance for any advice.
[03:39:07] -!- c-log has quit [Ping timeout: 240 seconds]
[03:41:23] -!- c-log has joined #linuxcnc-devel
[04:20:11] <KimK> jthornton: I thought it wouldn't hurt to try a test build with https://mirrors.edge.kernel.org and https://mirrors.edge.kernel.org I haven't done this before, but so far everything seems OK(?)
[04:24:43] <KimK> It's running make now, I'll be back later. I'll hold off on the two install steps until after I hear your advice. Thanks again.
[10:22:59] -!- hazzy has joined #linuxcnc-devel
[10:33:49] -!- Roguish_ has joined #linuxcnc-devel
[10:35:17] -!- Roguish has quit [Ping timeout: 250 seconds]
[10:35:29] Roguish_ is now known as Roguish
[11:15:25] -!- Roguish_ has joined #linuxcnc-devel
[11:17:33] -!- Roguish has quit [Ping timeout: 255 seconds]
[11:17:35] Roguish_ is now known as Roguish
[12:47:32] -!- Connor has quit [Ping timeout: 245 seconds]
[15:31:30] -!- Connor has joined #linuxcnc-devel
[17:01:08] -!- micges has joined #linuxcnc-devel